User`s guide

8-port Gigabit Ethernet Switch User’s Guide
74
Figure 6-19. Switch Mode Selection screen
The field Select switch operation mode:< > can be toggled using the space bar to one of the two switch operation
modes: Layer 2 Only, Support IEEE 802.1Q VLANs and IP Routing, Support IEEE 802.1Q VLANs.
To make a change in the operation mode of the Switch effective, highlight APPLY and press Enter.
Figure 6-20. Change Mode Confirmation screen
Type y and press Enter. The Switch will then save the changes made during the current session and reboot. The Switch
must be rebooted to change the operation mode.