User`s guide

DES-3226S Layer 2 Switch CLI Reference
90
show error ports
Purpose Used to display the error statistics for a range of
ports.
Syntax show error ports <portlist>
Description This command will display all of the packet error
statistics collected and logged by the switch for
a given port list.
Parameters
<portlist> − Specifies a range of ports to be
displayed. The port list is specified by listing the
lowest switch number and the beginning port
number on that switch, separated by a colon.
Then the highest switch number, and the
highest port number of the range (also
separated by a colon) are specified. The
beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch
number 2, port 4. 1:3-2:4 specifies all of the
ports between switch 1, port 3 and switch 2, port
4 − in numerical order.
Restrictions None.