User`s guide

DES-3226S Layer 2 Switch CLI Reference

INTRODUCTION

The DES-3226 Switch can be managed through the switch’s serial port,

Telnet, or the Web-based management agent. The Command Line Interface

(CLI) can be used to configure and manage the switch via the serial port or

Telnet interfaces.

This manual provides a reference for all of the commands contained in the

CLI. Configuration and management of the switch via the Web-based

management agent is discussed in the User’s Guide.

Accessing the Switch via the Serial Port

The switch’s serial port’s default settings are as follows:

• 9600 baud

• no parity

• 8 data bits

• 1 stop bit

A computer running a terminal emulation program capable of emulating a VT-

100 terminal and a serial port configured as above is then connected to the

switch’s serial port via an RS-232 DB-9 cable.

With the serial port properly connected to a management computer, the

following screen should be visible. If this screen does not appear, try pressing

Ctrl+r to refresh the console screen.