User`s guide

DES-3226S Layer 2 Switch CLI Reference
264
24
TIME AND SNTP COMMANDS
The Simple Network Time Protocol (SNTP) (an adaptation of the Network
Time Protocol (NPT)) commands in the Command Line Interface (CLI) are
listed (along with the appropriate parameters) in the following table.
Command Parameters
config sntp
{primary <ipaddr> | secondary <ipaddr> | poll-interval
<int 30-99999>
}(
1
)
show snt
p
enable snt
p
disable snt
p
confi
g
time <date ddmmm
yyyy
> <time hh:mm:ss >
config time-zone
{operator(1) [+ | -] | hour(2) <gmt_hour 0-13> | min(3)
<minute 0-59>
}
config dst
[disable|repeating {s-week<start_week 1-4,last>
| s-wday <start_weekday sun-sat>
| s-mth <start_mth 1-12>
| s-time <start_time hh:mm>
| e-week <end_week 1-4,last>
| e-wday <end_weekday sun-sat>
| e-mth <end_mth 1-12>
| e-time <end_time hh:mm>
| offset [30 | 60|90|120]}
| annual {s-date <start_date 1-31>
| s-mth <start_mth 1-12>
| s-time <start_time hh:mm>
| e-date <end_date 1-31>
| e-mth <end_mth 1-12>
| e-time <end_time hh:mm>
|
offset
[
30
|
60
|
90
|
120
]}]}
show time
Each command is listed, in detail, in the following sections.