User`s guide

DES-3226S Layer 2 Switch CLI Reference
251
config access_profile
fin - Specifies finish TCP flag field.
udp − Specifies that the Switch will examine the
Universal Datagram Protocol (UDP) field in each
packet.
src_port <value 0-65535> − Specifies that the access
profile will apply only to packets that have this UDP
source port in their header.
dst_port <value 0-65535> − Specifies that the access
profile will apply only to packets that have this UDP
destination port in their header.
protocol_id <value 0-255> − Specifies that the Switch
will examine the Protocol field in each packet and if
this field contains the value entered here, apply the
following rules.
user_define <hex 0x0-0xfffffff> − Specifies a mask to
be combined with the value found in the frame header
using a logical AND operation.
priority <value 0-7> − Specifies that the access profile
will apply to packets that contain this value in their
802.1p priority field of their header.
replace_priority − This parameter is specified if you
want to change the 802.1p user priority of a packet
that meets the specified criteria. Otherwise, a packet
will have its incoming 802.1p user priority re-written to
its original value before being transmitted from the
Switch.
replace_dscp <value 0-63> − Allows you to specify a
value to be written to the DSCP field of an incoming
packet that meets the criteria specified in the first part
of the command. This value will over-write the value in
the DSCP field of the packet.
delete <value 1-255> − Specifies the access ID of a
rule you want to delete.