User`s guide

DES-3226S Layer 2 Switch CLI Reference
249
config access_profile
add access_id <value 1-255> − Adds an additional rule
to the above specified access profile. The value
specifies the relative priority of the additional rule. The
lower access ID, the higher the priority the rule will be
given.
ethernet − Specifies that the Switch will look only into
the layer 2 part of each packet.
vlan <vlan_name 32> − Specifies that the access
profile will apply to only to this VLAN.
source_mac <macaddr> − Specifies that the access
profile will apply to only packets with this source MAC
address.
destination_mac <macaddr> − Specifies that the
access profile will apply to only packets with this
destination MAC address.
802.1p <value 0-7> − Specifies that the access profile
will apply only to packets with this 802.1p priority
value.
ethernet_type <hex 0x0-0xffff> − Specifies that the
access profile will apply only to packets with this
hexadecimal 802.1Q Ethernet type value in the packet
header.
ip − Specifies that the Switch will look into the IP fields
in each packet.
vlan <vlan_name 32> − − Specifies that the access
profile will apply to only to this VLAN.
source_ip <ipaddr> − Specifies that the access profile
will apply to only packets with this source IP address.
destination_id <value 0-255> − Specifies that the
access profile will apply to only packets with this
destination IP address.
dscp <value 0-63> − Specifies that the access profile