User`s guide

DES-3226S Layer 2 Switch CLI Reference
243
create access_profile
Purpose Used to create an access profile on the Switch and to
define which parts of each incoming frame’s header
the Switch will examine. Masks can be entered that
will be combined with the values the Switch finds in
the specified frame header fields. Specific values for
the rules are entered using the config
access_profile command, below.
Syntax
create access_profile
[ethernet {vlan | source_mac <macmask> |
destination_mac <macmask> | 802.1p |
ethernet_type} |
ip {vlan|source_ip_mask<netmask> |
destination_ip_mask <netmask> | dscp |
[icmp {type | code} | igmp {type} |
tcp {src_port_mask <hex 0x0-0xffff> |
flag_mask [ all | { urg | ack |psh |rst |syn| fin } ] }
| dst_port_mask <hex 0x0-0xffff>} |
udp {src_port_mask <hex 0x0-0xfff> |
dst_port_mask <hex 0x0-0xffff>} |
protocol_id {user_mask <hex 0x0-0xffffffff>} ] }
{[permit | deny]|profile_id <value 1-255>}
Description
The create access_profile command is used to
create an access profile on the Switch and to define
which parts of each incoming frame’s header the
Switch will examine. Masks can be entered that will
be combined with the values the Switch finds in the
specified frame header fields. Specific values for the
rules are entered using the config access_profile
command, below.
Parameters
ethernet − Specifies that the Switch will examine the
layer 2 part of each packet header.
vlan − Specifies that the Switch will examine the
VLAN part of each packet header.
source_mac <macmask> − Specifies a MAC address