User`s guide

DES-3226S Layer 2 Switch CLI Reference
224
config 802.1x auth_parameter
Purpose Used to configure the 802.1x Authentication
parameters on a range of ports. The default
parameter will return all ports in the specified
range to their default 802.1x settings.
Syntax
config 802.1x auth_parameter
ports [<portlist>|all]
[default|{direction [both|in]|port_control
[force_unauth|auto|force_auth]| quiet_period
<sec 0-65535>| tx_period <sec 1-65535>|
supp_timeout <sec 1-65535>|
server_timeout <sec 1-65535>| max_req
<value 1-10>|reauth_period <sec 1-65535>
|enable_reauth [enabled|disabled]}]
Description
The config 802.1x auth_parameter command
is used to configure the 802.1x Authentication
parameters on a range of ports. The default
parameter will return all ports in the specified
range to their default 802.1x settings.
Parameters
<portlist> − Specifies a range of ports. The port
list is specified by listing the lowest switch
number and the beginning port number on that
switch, separated by a colon. Then the highest
switch number, and the highest port number of
the range (also separated by a colon) are
specified. The beginning and end of the port list
range are separated by a dash. For example,
1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4
specifies all of the ports between switch 1, port
3 and switch 2, port 4 − in numerical order.
all − Specifies all of the ports on the switch.
default − Returns all of the ports in the specified
range to their 802.1x default settings.
direction [both|in] − Determines whether a