User`s guide

DES-3226S Layer 2 Switch CLI Reference
222
config 802.1x capability
Purpose Used to configure the 802.1x capability of a
range of ports on the switch.
Syntax
config 802.1x capability ports [<portlist>|all]
[authenticator|none]
Description
The config 802.1x command has four
capabilities that can be set for each port.
Authenticator, Supplicant, Authenticator and
Supplicant, and None.
Parameters
<portlist> − Specifies a range of ports. The port
list is specified by listing the lowest switch
number and the beginning port number on that
switch, separated by a colon. Then the highest
switch number, and the highest port number of
the range (also separated by a colon) are
specified. The beginning and end of the port list
range are separated by a dash. For example,
1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4
specifies all of the ports between switch 1, port
3 and switch 2, port 4 − in numerical order.
all − Specifies all of the ports on the switch.
authenticator − A user must pass the
authentication process to gain access to the
network.
none − The port is not controlled by the 802.1x
functions.
Restrictions Only administrator-level users can issue this
command.