User`s guide

DES-3226S Layer 2 Switch CLI Reference
217
show 802.1x
Purpose Used to display the current configuration of the
802.1x server on the switch.
Syntax show 802.1x [auth_state | auth_configuration]
{ports <portlist>}
Description The show 802.1x command is used to display
the current configuration of the 802.1x Port-
based Network Access Control server
application on the switch.
Parameters auth_state – Displays the current 802.1x
authentication state of the specified ports.
auth_configuration - Displays the current 802.1x
authentication configuration of the specified
ports.
ports <portlist> − Specifies a range of ports. The
port list is specified by listing the lowest switch
number and the beginning port number on that
switch, separated by a colon. Then the highest
switch number, and the highest port number of
the range (also separated by a colon) are
specified. The beginning and end of the port list
range are separated by a dash. For example,
1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4
specifies all of the ports between switch 1, port
3 and switch 2, port 4 − in numerical order.
The following details what is displayed:
802.1x Enabled|Disabled − Shows the current
status of 802.1x functions on the switch.
Authentication Protocol: Radius_Eap − Shows
the authentication protocol suite in use between
the switch and a Radius server.
Port number − Shows the physical port number
on the switch.