User`s guide

DES-3226S Layer 2 Switch CLI Reference
195
config ipif System
Purpose Used to configure the System IP interface.
Syntax
config ipif System [{vlan <vlan_name
32>|ipaddress <network_address>|state
[enabled|disabled]|bootp|dhcp}]
Description This command is used to configure the System
IP interface on the switch.
Parameters
<network_address> − IP address and netmask
of the IP interface to be created. You can
specify the address and mask information using
the traditional format (for example,
10.1.2.3|255.0.0.0 or in CIDR format,
10.1.2.3|16).
<vlan_name 32> − The name of the VLAN
corresponding to the System IP interface.
state [enabled|disabled] − Allows you to enable
or disable the IP interface.
bootp − Allows the selection of the BOOTP
protocol for the assignment of an IP address to
the switch’s System IP interface.
dhcp − Allows the selection of the DHCP
protocol for the assignment of an IP address to
the switch’s System IP interface.
Restrictions Only administrator-level users can issue this
command.