User`s guide

DES-3226S Layer 2 Switch CLI Reference
182
create link_aggregation
Purpose Used to create a link aggregation group on the
switch.
Syntax
create link_aggregation group_id <value>
{type[lacp|static]}
Description This command will create a link aggregation
group with a unique identifier.
Parameters
<value> − Specifies the group id. The switch
allows up to 6 link aggregation groups to be
configured. The group number identifies each of
the groups.
type – Specify the type of link aggregation used
for the group. If the type is not specified the
default type is static.
lacp – This designates the port group as LACP
compliant. LACP allows dynamic adjustment to
the aggregated port group. LACP compliant
ports may be further configured (see config
lacp_ports). LACP compliant must be connected
to LACP compliant devices.
static – This designates the aggregated port
group as static. Static port groups can not be
changed as easily as LACP compliant port
groups since both linked devices must be
manually configured if the configuration of the
trunked group is changed. If static link
aggregation is used, be sure that both ends of
the connection are properly configured and that
all ports have the same speed/duplex settings.
Restrictions Only administrator-level users can issue this
command.