User`s guide

DES-3226S Layer 2 Switch CLI Reference
181
17
LINK AGGREGATION COMMANDS
The link aggregation commands in the Command Line Interface (CLI) are
listed (along with the appropriate parameters) in the following table.
Command Parameters
create
link_aggregation
group_id <value> {type[lacp|static]}
delete
link_aggregation
group_id <value>
config
link_aggregation
group_id <value>
master_port <port>
ports <portlist>
state [enabled|disabled]
config
link_aggregation
algorithm
mac_source
mac_destination
mac_source_dest
ip_source
ip_destination
ip_source_dest
show
link_aggregation
group_id <value>
algorithm
config lacp_ports <portlist> mode [active|passive]
show lacp_ports {<portlist>}
Each command is listed, in detail, in the following sections.