User`s guide

DES-3226S Layer 2 Switch CLI Reference
158
Example usage:
To configure 802.1p default priority on the switch:
DES-3226S:4#config 802.1p default_priority all 5
Command: config 802.1p default_priority all 5
Success.
DES-3226S:4#
show 802.1 default_priority
Purpose Used to display the currently configured 802.1p
priority value that will be assigned to an
incoming, untagged packet before being
forwarded to its destination.
Syntax
show 802.1p default_priority {<portlist>}
Description
The show 802.1p default_priority command
displays the currently configured 802.1p priority
value that will be assigned to an incoming,
untagged packet before being forwarded to its
destination.
Parameters
<portlist> − Specifies a range of ports to be
configured. The port list is specified by listing
the lowest switch number and the beginning
port number on that switch, separated by a
colon. Then the highest switch number, and the
highest port number of the range (also
separated by a colon) are specified. The
beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch
number 2, port 4. 1:3-2:4 specifies all of the
ports between switch 1, port 3 and switch 2, port
4 − in numerical order.