User`s guide

DES-3226S Layer 2 Switch CLI Reference
157
config 802.1p default_priority
Purpose Used to specify how to map an incoming
packet that has no 802.1p priority tag to one of
the switch’s four hardware priority queues.
Syntax
config 802.1p default_priority [<portlist>|all]
<priority 0-7>
Description
The config 802.1p default_priority command
allows you to specify the 802.1p priority value
an untagged, incoming packet will be assigned
before being forwarded to its destination.
Parameters
<portlist> − Specifies a range of ports to be
configured. The port list is specified by listing
the lowest switch number and the beginning
port number on that switch, separated by a
colon. Then the highest switch number, and
the highest port number of the range (also
separated by a colon) are specified. The
beginning and end of the port list range are
separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of
the ports between switch 1, port 3 and switch
2, port 4 − in numerical order.
all − Specifies that the config 802.1p
default_priority command will be applied to all
ports on the switch.
<priority 0-7> − Specifies the 802.1p priority
value that an untagged, incoming packet will
be given before being forwarded to its
destination.
Restrictions Only administrator-level users can issue this
command.