User`s guide

DES-3226S Layer 2 Switch CLI Reference
147
show bandwidth_control
Purpose Used to display the bandwidth control
configuration on the switch.
Syntax
show bandwidth_control {<portlist>}
Description
The show bandwidth_control command
displays the current bandwidth control
configuration on the switch, on a port-by-port
basis.
Parameters
<portlist> − Specifies a range of ports to be
configured. The port list is specified by listing
the lowest switch number and the beginning
port number on that switch, separated by a
colon. Then the highest switch number, and the
highest port number of the range (also
separated by a colon) are specified. The
beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch
number 2, port 4. 1:3-2:4 specifies all of the
ports between switch 1, port 3 and switch 2, port
4 − in numerical order.
Restrictions None.