User`s guide

DES-3226S Layer 2 Switch CLI Reference
145
config bandwidth_control
Purpose Used to configure bandwidth control on a by-
port basis.
Syntax
config bandwidth_control <portlist> {re_rate
[no_limit|<value 1-1000>]|tx_rate
[no_limit|<value 1-1000>]}
Description
The config bandwidth_control command is
used to configure bandwidth on a by-port basis.
Parameters
<portlist> − Specifies a range of ports to be
configured. The port list is specified by listing
the lowest switch number and the beginning
port number on that switch, separated by a
colon. Then the highest switch number, and the
highest port number of the range (also
separated by a colon) are specified. The
beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch
number 2, port 4. 1:3-2:4 specifies all of the
ports between switch 1, port 3 and switch 2, port
4 − in numerical order.
rx_rate − Specifies that one of the parameters
below (no_limit or <value 1-1000>) will be
applied to the rate at which the above specified
ports will be allowed to receive packets
no_limit − Specifies that there will be no limit on
the rate of packets received by the above
specified ports.
<value 1-1000> − Specifies the packet limit, in
Mbps, that the above ports will be allowed to
receive.
tx_rate − Specifies that one of the parameters
below (no_limit or <value 1-1000>) will be
applied to the rate at which the above specified
ports will be allowed to transmit packets.