User`s guide

DES-3226S Layer 2 Switch CLI Reference
110
config stp
Purpose Used to setup STP and RSTP on the switch.
Syntax
config stp {maxage <value>|hellotime
<value>|forwarddelay <value>|priority
<value>|fbpdu [enabled|disabled]|
txholdcount <1-10>| version[rstp|stp]}
Description This command is used to setup the Spanning
Tree Protocol (STP) for the entire switch.
Parameters
maxage <value> − The maximum amount of
time (in seconds) that the switch will wait to
receive a BPDU packet before reconfiguring
STP. The default is 20 seconds.
hellotime <value> − The time interval between
transmission of configuration messages by the
root device. The default is 2 seconds.
forwarddelay <value> − The maximum amount
of time (in seconds) that the root device will wait
before changing states. The default is 15
seconds.
priority <value> − A numerical value between 0
and 61440 that is used in determining the root
device, root port, and designated port. The
device with the highest priority becomes the root
device. The lower the numerical value, the
higher the priority. The default is 32,768.
fbpdu [enabled|disabled] − Allows the
forwarding of STP BPDU packets from other
network devices when STP is disabled on the
switch. The default is enabled.
txholdcount <1-10> - the maximum number of
Hello packets transmitted per interval. Default
value = 3.
version [rstp|stp] - select the Spanning Tree
Protocol version used for the switch. For IEEE