User`s guide

DES-3226S Layer 2 Switch CLI Reference
106
local6 − Specifies that local use 6 messages will
be sent to the remote host. This corresponds to
number 22 from the list above.
local7 − Specifies that local use 7 messages will
be sent to the remote host. This corresponds to
number 23 from the list above.
udp_port <int> − Specifies the UDP port number
that the syslog protocol will use to send
messages to the remote host.
ipaddress <ipaddr> − Specifies the IP address
of the remote host where syslog messages will
be sent.
state [enabled|disabled] − Allows the sending of
syslog messages to the remote host, specified
above, to be enabled and disabled.
Restrictions Only administrator-level users can issue this
command.
Example usage:
To configure a syslog host:
DES-3226S:4#config syslog host all severity all facility local0
Command: config syslog host all severity all facility local0
Success.
DES-3226S:4#