User`s guide

DGS-3100 Gigabit Ethernet Switch Manual

MANDS VLAN COM

The VLAN commands in the Comm are listed (along with the appropriate parameters) in

the following

and Line Interface (CLI)

table.

Command Parameter

create vla <vlan_n name 32> {tag <vlanid 2-4094>}

delete vlan <vlan_name 32>

config vlan

<vlan_ h1-

32> ]

name 32> [add [tagged | untagged | forbidden] | delete] [ <portlist> | <c

config gvrp

[<port

accep

list> | <ch1-32> | all] { ingress_checking [enable | disable] |

table_frame [tagged_only | admit_all] | pvid <vlanid 1-4094>}

enable gvrp

disable gvrp

show vlan {<vlan_name 32>}

show gvrp {<portlist> | <ch1-32> ]}

Each command is listed i

n detail, as follows:

create vlan

Purpose create a VLAN on the Switch. To

Syntax

create vlan <vlan_name 32> {tag <vlanid 2-4094>}

Description The create vlan command creates a VLAN on the Switch.

Parameters <vlan_name 32> − The name of the VLAN to be created.

ated. The

94.

tag <vlanid 2-4094> − The VLAN ID of the VLAN to be cre

allowed values range from 2 to 40

Restrictions ame can be up to 32 characters. If the VLAN is not Each VLAN n

given a tag, it will be a port-based VLAN. Only administrator-level

users can issue this command.

Example usage:

To cr 1, tag 2:

100

eate a VLAN v

DGS3 # create vlan v1 tag 2

Success.

GS3100#