User`s guide

81
Syntax
show 802.1p user_priority
Description The show 802.1p user_priority command displays the current
mapping of an incoming packet’s 802.1p priority value to one of the
Switch’s four hardware priority queues.
Parameters None.
Restrictions None.
Example usage:
To show 802.1p user priority:
DGS3100
QOS Clas
Priority-0
Priority-1 ss-0>
y-2
Priority-3
Priority-4
Priority-5
Priority-6
Priority-7
DGS3100
# show 802.1p user_priority
s of Traffic
-> <Class-0>
-> <Cla
Priorit -> <Class-0>
-> <Class-1>
-> <Class-1>
-> <Class-2>
-> <Class-2>
-> <Class-3>
#
config 802.1p default_priority
Purpose ming untagged packet that To assign an 802.1p priority tag to an inco
has no 802.1p priority tag.
Syntax
t_priority [<portlist> | all] <priority 0-7>
config 802.1p defaul
Description The config 802.1p default_priority command specifies the 802.1p
iority value an untagged, incoming packet is assigned before being
warded to its destination.
pr
for
Parameters <portlist> − A port or range of ports to be configured.
all − Specifies that the config 802.1p default_priority command
e Switch.
<priority 0-7> − The 802.1p priority value that an untagged, incoming
applies to all ports on th
packet is granted before being forwarded to its destination.
Restrictions Only strator-level users can issue this command. admini
Example usa
To co default pr
100 802.1p default_priority all 5
s.
ge:
nfigure 802.1p iority on the Switch:
DGS3 # config
Succes
DGS3100#