User`s guide

DGS-3100 Gigabit Ethernet Switch Manual
64
y : 15
ax Age : 20
unt : 3
Forwarding BPDU : Enabled
Forward Dela
M
TX Hold Co
DGS3100#
show stp ports
Purpose To display the Switch’s current instance_id configuration.
Syntax
show stp ports <portlist>}
Description The show stp ports command displays the STP Instance Settings
and STP Instance Operational Status currently implemented on the
Switch.
Parameters The port list is
(also
<portlist> A port or a range of ports to be viewed.
specified by listing the lowest switch number and the beginning port
number on that switch, separated by a colon. Then the highest
switch number, and the highest port number of the range
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-
2:4 specifies all of the ports between switch
1, port 3 and switch 2,
port 4 in numerical order.
Restrictions None.
Example usage:
To show stp ports 1 through 9
DGS3100# show
rt Inform
---------------------------------
0000,Edge Port : No /No,P2P : Auto /Yes
Msti Designated Bridge Internal PathCost Prio Status Role
-------- - ------------------ ------------------------- ----- ---------------- ----------
0 8000 00:23:27:26:46:00 200000 128 Disabled Disabled
DGS3100#
on switch one:
stp ports 1:9
MSTP Po ation
Port Index : 1:9,Port STP enabled
External PathCost : Auto/20
---------------
show stp instance_id
Purpose To display the Switch’s STP instance configuration
Syntax
ow stp instance_id <value 0-15>}
sh
Description The show stp instance_id command displays the Switch’s current
STP Instance Settings and the STP Instance Operational Status.
Parameters <value 0-15> - The value of the previously configured instance_id on