User`s guide

53
show syslog
Purpose To display the syslog protocol status.
Syntax
show syslog
Description or The show syslog command displays the syslog status (enabled
disabled).
Parameters None.
Restrictions None.
Example usage:
To display the current status o
100
log Global State: Enabled
DGS3100#
f the syslog function:
DGS3 # show syslog
Sys
crea g host te syslo
Purpose To create a new syslog host.
Syntax
create
[inform
syslog host <index 1-4> ipaddress <ipaddr> {severity
ational | warning | all] | facility [local0 | local1| local2 |
local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number>}
Description The create syslog host command creates a new syslog host.
Parameters
vailable
4.
r. These are
Alert: action must be taken immediately
ritical conditions
Error: error conditions
Warning: warning conditions
dition
ges
all − Specifies that the command is to be applied to all hosts.
<index 1-4> − The syslog host index id. There are four a
indices, numbered 1 to
ipaddress <ipaddr> − The IP address of the remote host to which
syslog messages are to be sent.
severity − The message severity level indicato
described in the table below (Bold font indica
tes that the
corresponding severity level is currently supported on the Switch):
Numerical Severity
Code
0 Emergency: system is unusable
1
2 Critical: c
3
4
5 Notice: normal but significant con
6 Informational: informational messages
7 Debug: debug-level messa