User`s guide

DGS-3100 Gigabit Ethernet Switch Manual
48
8
ORK MONITORING COMMANDS NETW
The Network Monitoring command nterface (CLI) are listed (along with the appropriate
parameters) in the following table.
s in the Command Line I
Command Parameter
show packet ports <portlist>
show error ports <portlist>
show utilization
clear counters
clear log
show log {index <value>}
enable syslog
disable syslog
show syslog
create syslog host
rity [informational | warning | all] | facility
l3 | local4 | local5 | local6 | local7] | udp_port
<index 1-4> ipaddress <ipaddr> {seve
[local0 | local1| local2 | loca
<udp_port_number>}
config syslog host
[informational | warning | all] | facility [local0 | local1 |
l5 | local6 | local7] | udp_port <udp_port_number> |
ipaddress <ipaddr>}
[all | <index 1-4>] {severity
local2 | local3 | local4 | loca
delete syslog host [<index 1-4> | all]
show syslog host {<index 1-4>}
Each command is listed i
n detail, as follows:
show packet ports
Purpose To display statistics about the packets sent and received by the
Switch.
Syntax
sho
w packet ports <portlist>
Description The show packet ports command displays statistics about packets
he port list. The results are
B, and C in the window
is relevant to the size of the packets, Table B is
sent and received by ports specified in t
separated into three tables, labeled A,
below. Table A
relevant to the type of packets and Table C is relevant to the type of
frame associated with these packets.
Parameters <portlis
displaye
t> − A port or range of ports whose statistics are to be
d.
Restrictions None.