User`s guide

DGS-3100 Gigabit Ethernet Switch Manual
46
7
DOWNLOAD/UPLOAD COMMANDS
The Download/Upload commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
download
[firmware <ipaddr> <path_filename 64> | boot <ipaddr> <path_filename 64> |
n <ipaddr> <path_filename 64> {startup | running}]
configuratio
upload uration <ipaddr> <path_filename 64> {startup | running} config
Each command is listed in detail, as follows:
download
Purpose To download and install a firmware, boot, or switch configuration file
from a TFTP server.
Syntax
download [firmware <ipaddr> <path_filename 64> | boot
<ipaddr> <path_filename 64> | configuration <ipaddr>
<path_filename 64> {startup | running}]
Description The download command downloads a firmware, boot, or switch
configuration file from a TFTP server.
Parameters
− Downloads a switch configuration file from a TFTP
− The IP address of the TFTP server.
<path_filename 64> − The DOS path and filename of the firmware
or switch configuration file, up to 64 characters, on the TFTP server.
ple, C:\31xx.had.
startup − Indicates the Startup Configuration file is to be
aded.
− Indicates the Running Configuration file is to be
firmware − Downloads and installs firmware on the Switch from a
TFTP server.
boot − Downloads a boot file from a TFTP server.
configuration
server.
<ipaddr>
For exam
downlo
running
downloaded.
Restrictions P server must be on the same IP subnet as the Switch.
n issue this command.
The TFT
Only administrator-level users ca
Example usa
To download a firmware file:
DGS3100# download
01–Jan–2000 01:19:4
dgs_3lxx—10032.ros e
!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
ge:
firmware 1.1.1.23 1\dgs_31xx-10032.ros
8 %COPY–I–FILECPY: Files Copy – source URL tftp://1.1.1.23 /1\
destination URL Unit all flash://imag
!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!! !!!!!!!!!!