User`s guide

29
Command Parameter
disable snmp
authenticate trap
show snmp traps
config snmp
system_contact
<sw_contact>
config snmp
system_location
<sw_location>
config snmp
system_name
e> <sw_nam
Each command is listed in
detail, as follows:
create snmp user
Purpose To create a new SNMP user and add the user to an SNMP group.
Syntax
p user <username 24> <groupname 30> [encrypted
create snm
[by_password auth [md5 <auth_password 1-32> | sha
<auth_password 1-32>] | by_key auth [md5 <auth_key 32 or
64>| sha<auth_key 40 or 72>]]]
Description The create snmp user command creates a new SNMP user and
adds the user to an existing SNMP group
.
Parameters
to enter a
password for authentication and privacy. The password is
defined by specifying the auth_password below. This
method is recommended.
ncryption
key for authentication and privacy. The key is defined by
specifying the key in hex form below. This method is not
recommended.
th - The user may also choose the type of authentication
ms used to authenticate the snmp user. The choices are:
• md5 − Specifies that the HMAC-MD5-96 authentication
level will be used. md5 may be utilized by entering one
of the following:
• <auth password 1-32> - A string of between 1 and
e
host.
rize the agent to receive packets
AC-SHA-96 authentication
<username 24> − The new SNMP username, up to 24 alphanumeric
characters.
<groupname 30> − The SNMP groupname the new SNMP user will
be associated with, up to 30 alphanumeric characters.
encrypted – Allows the user to choose a type of authorization for
authentication using SNMP. The user may choose:
• by_password – Requires the SNMP user
• by_key – Requires the SNMP user to enter an e
au
algorith
32 alphanumeric characters used to authorize th
agent to receive packets for the
• <auth_key 32 or 64> - A string of exactly 32 or 64
alphanumeric characters, in hex form, to define the
key used to autho
for the host.
• sha − Specifies that the HM