User`s guide

DGS-3100 Gigabit Ethernet Switch Manual
24
5
MMANDS SWITCH PORT CO
The Switch nds in th priate
parameters) in the following table.
Port comma e Command Line Interface (CLI) are listed (along with the appro
Command Parameter
config ports
[all | < ] {speed [auto | 10_half | 10_full | 100_half | 100_full | 1000_full] |
flow_control [enable | disable | auto] | learning [enable | disable] | state [enable |
]}
portlist>
disable
show ports {<portlist>}
config ports descriptio <portlist> <string 1-64> n
delete ports descriptio <portlist> n
show ports description >} {<portlist
Each command is listed in detail, as follows:
config ports
Purpose To configure the Switch’s Ethernet port settings.
Syntax
config ports [all | <portlist>] {speed [auto | 10_half | 10_full |
100_half | 100_full | 1000_full] | flow_control [enable | disable |
auto] | learning [enable | disable
] | state [enable | disable]}
Description The config ports command configures the Switch’s Ethernet port
. Only the ports listed in the <portlist> will be affected.
settings
Parameters <portlist> − A port or range of ports to be configured.
nfigures all ports on the Switch.
t or range of ports, with the addition
• auto − Enables auto-negotiation for the specified range of
ports.
• [10 | 100 | 1000] − Configures the speed in Mbps for the
specified range of ports.
• [half | full] − Configures the specified range of ports as either
half-duplex.
nable] – Enables flow control for the specified ports.
rts.
otiation of flow control for the
orts.
all − Co
speed – Sets the speed of a por
of one of the following:
full or
flow_control [e
flow_control [disable] – Disables flow control for the specified po
flow_control [auto] – Specifies auto-neg
specified ports.
learning [enable | disable] − Enables or disables the MAC address
learning on the specified range of p
state [enable | disable] − Enables or disables the specified range of
ports.
Restrictions Only administrator-level users can issue this command.
Example usage: