User`s guide

15
ata Bits : 8
: None
top Bits : 1
t : 10 mins
DGS3100#
Baud Rate : 9600
D
Parity Bits
S
Auto-Logou
config serial_port
Purpose To configure the serial port.
Syntax
15_minutes]}
config serial_port {baud_rate [9600 | 19200 | 38400] auto_logout
[never | 2_minutes | 5_minutes| 10_minutes |
Description The show serial_port command configures the serial port’s baud
rate and auto logout settings.
Parameters − The serial bit rate used to
auto_logout - The amount of time the Switch’s serial port can be idle
alues are:
time the console can
er input.
2_minutes − The console will log out the current user if there is no
r input for 2 minutes.
5_minutes − The console will log out the current user if there is no
er input for 5 minutes.
10_minutes − The console will log out the current user if there is no
user input for 10 minutes.
15_minutes − The console will log out the current user if there is no
user input for 15 minutes.
baud rate [9600 | 19200 | 38400]
communicate with the management host.
before automatically logging out. The possible v
never − There is no time limit on the length of
be open with no us
use
us
Restrictions Only administrator-level users can issue this command.
Example usa
To co e baud rate:
DGS3100
s.
DGS3100#
ge:
nfigure th
# config serial_port baud_rate 9600
Succes
enable clipaging
Purpose To pause the scrolling of the console screen after each page when a
ow command displays more than one page.
sh
Syntax
enable clipaging
Description The enable clipaging command pauses the scrolling of the console
screen at the end of each page when issuing a command which