User`s guide

109
DGS3100# config 802.1x reauth port_based ports 1-18
Success.
DGS3100#
config radius add
Purpose To configure the settings the Switch will use to communicate with a
RADIUS server.
Syntax
config radius add [<server_ip>] [key <passwd 32>] [default |
{auth_port <udp_port_number 1-65535> | acct_port
<udp_port_number 1-65535>}]
Description The config radius add command configures the settings the Switch
will use to communicate with a RADIUS server.
Parameters <server_ip> – The IP address of the RADIUS server.
key – Specifies that a password and encryption key are to be used
between the Switch and the RADIUS server.
<passwd 32> – The shared-secret key used by the RADIUS server
and the Switch. Up to 32 characters can be used.
default – Uses the default udp port number in both the auth_port and
acct_port settings.
auth_port <udp_port_number 1-65535> – The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535> – The UDP port number for
accounting requests. The default is 1813.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the RADIUS server communication settings:
DGS3100# config radius add 10.48.74.121 key dlink default
Success.
DGS3100#
config radius delete
Purpose To delete a previously entered RADIUS server configuration.
Syntax
config radius delete <server_ip>
Description The config radius delete command deletes a previously entered
RADIUS server configuration.
Parameters <server_ip> – The IP address of the RADIUS server.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete previously configured RADIUS server communication settings: