User`s guide

DGS-3100 Gigabit Ethernet Switch Manual
106
to wait for a response
sending
packets to the supplicant.
the time interval between successive
reauthentications.
or not to reauthenticate.
packets.
ServerTimeout − Shows the length of time
from a RADIUS server.
MaxReq − Shows the maximum number of times to retry
ReAuthPeriod − Shows
ReAuthenticate: true/false − Shows whether
Parameters rtlist> − Specifies a port or range of ports to be viewed. ports <po
Restrictions Only administrator-level users can issue this command.
Example usage:
To display the 802.1x configurations:
DGS3100# show 802.1x auth_configuration ports 1
nabled
Authentic
Authentic
Port num
penCrlD
Port Control
uietPer
TxPeriod : 30 sec
eAuthPeriod : 3600 sec
Authenticate : false
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
802.1X : E
ation Mode : Port_based
ation Method : None
ber : 1
AdminCrl
O
Dir : both
ir : both
: forceAuthorized
Q iod : 60 sec
SuppTimeout : 30 sec
ServerTimeout : 30 sec
MaxReq : 2 times
R
Re
config 802.1x auth_parameter ports
Purpose
To configure the 802.1x authentication parameters on a range of
ports. The default parameter will return all ports in the specified
range to their default 802.1x settings.
Syntax config 802.1x auth_parameter ports [<portlist> | all] [default |
{ port_control [force_unauth | auto | force_auth] | quiet_period
<sec 0-65535> | tx_pe
riod <sec 1-65535> | supp_timeout <sec 1-
-10> |
ble_reauth [enable |
65535> | server_timeout <sec 1-65535> | max_req <value 1
reauth_period <sec 300-4294967295> | ena
disable]}]
Description
The config 802.1x auth_parameter ports command configures the
802.1x authentication parameters on a range of ports. The default
all ports in the specified range to their default
parameter will return
802.1x settings.