User`s guide

103
18
802.1X COMMANDS
The 802 e appropriate parameters)
in the following table.
.1X commands in the Command Line Interface (CLI) are listed (along with th
Command Parameter
enable 802.1x
disable 802.1x
show 802.1x
auth_state
{ports <portlist>}
show 802.1x
auth_configuration
{ports <portlist>}
config 802
auth_para
[<portlist> | all] [default | { port_control [force_unauth | auto | force_auth] |
eriod <sec 1-65535> | supp_timeout <sec 1-
5535> | max_req <value 1-10> | reauth_period
<sec 3
.1x
meter ports
quiet_period <sec 0-65535> | tx_p
65535> | server_timeout <sec 1-6
00-4294967295> | enable_reauth [enable | disable]}]
config 802.1x init port_b st> | all] ased ports [<portli
config 802
auth_prot
[radiu
.1x
ocol
s | none]
config 802.1x reauth port_based ports [<portlist> | all]
config radius add
<serve {auth_port <udp_port_number 1-
65535
r_ip> ][ key <passwd 32>] [default |
> | acct_port <udp_port_number 1-65
535>}]
config radius delete <server_ip>
config radius
<serve
acct_p 35>}
r_ip> {| key <passwd 32> | auth_port <udp_port_number 1-65535> |
ort <udp_port_number 1-655
show radius
config 802.1x
auth_mode
ports <portlist> [port_based | mac_based]
config guest_vlan <vlan_name 32> state [enable| disable]
config guest_vlan ports <portlist>
show guest_vlan
Each command is listed in detail, as
follows:
enable 802.1x
Purpose To enable the 802.1x server on the Switch.
Syntax
enable 802.1x
Description The enable 802.1x command enables the 802.1x Port-based
Network Access control server application on the Switch.