User`s guide

DGS-3100 Gigabit Ethernet Switch Manual
98
17
IGMP SNOOPING COMMANDS
T
para
he IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the appropriate
meters) in the following table.
Command Parameter
config igm
[<vlan out <sec 60-16711450> | router_timeout <sec
1-167
p_snooping
_name 32> | all] {host_time
11450> | leave_timer <sec 0-16711450> | state [enable | disable]}
config router_port <vlan_name 32> [add | delete] <portlist>
enable igmp_snooping
disable igmp _snooping
show igmp_snooping {vlan <vlan_name 32>}
show
group
2>}
igmp_snooping
{vlan <vlan_name 3
show igmp_snooping
forwarding
{vlan <vlan_name 32>}
show router_port {vlan <vlan_name 32> | static | dynamic}
ach command is listed in detail, as follows:
E
config igmp_snooping
Purpose To configure IGMP snooping on the Switch.
Syntax
config igmp_snooping [<vlan_name 32> | all] {host_timeout
<sec 60-16711450> | router_timeout <sec 1-16711450> |
leave_timer <sec 0-16711450> | state [enable | disable]}
Description The config igmp_snooping command configures IGMP snooping
on the Switch.
Parameters <vlan_nam
is to be
e 32> − The name of the VLAN for which IGMP snooping
configured.
all – Specifies that IGMP snooping is to be configured for all VLANs
on the Switch.
11450> − Specifies the maximum amount
member of a multicast group without the
Switch receiving a host membership report. The default is 260
Specifies the maximum amount
of time a route can be a member of a multicast group without the
ship report. The default is 260
> − Leave timer. The default is 2
les or disables IGMP snooping for the
host_timeout <sec 60-167
of time a host can be a
seconds.
router_timeout <sec 1-16711450> −
Switch receiving a host member
seconds.
leave_timer <sec 0-16711450
seconds.
state [enable | disable] − Enab
specified VLAN.