User`s guide

DGS-3100 Gigabit Ethernet Switch Manual
96
16
BASIC IP COMMANDS
The Basic IP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command Parameter
config ipif system
[{ipaddress <network_address> | vlan <vlan_name 32> | state [enable | disable]}
| dhcp]
show ipif {system}
Each command is listed in e il, as follows:
d ta
config ipif system
Purpose ystem IP interface. To configure the S
Syntax
config ipif system [{ipaddress
<vlan_name 32>
<network_address> | vlan
| state [enable | disable]} | dhcp]
Description nd configures the System IP The config ipif system comma
interface on the Switch.
Parameters - The IP interface name to be configured. The default IP
name on the Switch is “System”. All IP interface
configurations done will be executed through this interface name.
dress> − IP address and netmask of the IP interface to
he address and mask information may be specified by
0.1.2.3/255.0.0.0 or in
the
.
witch’s System IP interface.
system
Interface
<network_ad
be created. T
using the traditional format (for example, 1
CIDR format, 10.1.2.3/16).
<vlan_name 32> − The name of the VLAN corresponding to
System IP interface.
state [enable | disable] − Enables or disables the IP interface
dhcp − Specifies the DHCP protocol for the assignment of an IP
address to the S
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the IP interface S
DGS3100
Success.
DGS3100
ystem:
# config ipif System ipaddress 10.48.74.122/8
#