User`s guide

DGS-3100 Gigabit Ethernet Switch Manual
94
DGS3100#
delete link_aggregation
Purpose To delete a previously configured link aggregation group.
Syntax
delete link_aggregation group_id <value 1-32>
Description te link_aggregation group_id command deletes a
configured link aggregation group.
The dele
previously
Parameters
ach of the groups.
group_id <value 1-8> − Specifies the group ID. The Switch allows up
to 8 link aggregation groups to be configured. The group number
identifies e
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete link aggregation group:
DGS3100# delete link_a ggregation group_id 1
Success.
DGS3100
#
config link_aggregation
Purpose To configure a previously created link aggregation group.
Syntax
config link_aggregation group_id <value 1-32> { ports <portlist>
| state [enable | disable] }
Description The config link_aggregation command configures a link
aggregation group that was created with the create
link_aggregation command above.
Parameters allows
g to the
y one port
aggregation group, that is, link aggregation groups may not overlap.
nable | disable] − Enables or disables the specified link
n group.
group_id <value 1-32> − Specifies the group ID. The Switch
up to 32 link aggregation groups to be configured. The group
number identifies each of the groups.
ports <portlist> − Specifies a port or range of ports to belon
link aggregation group. Ports may be listed in onl
state [e
aggregatio
Restrictions Only d. Link
aggregation groups may not overlap and must be contained on a
e switch.
administrator-level users can issue this comman
singl
Example usage:
To define a load-sh f ports, group-id 1, master port 5 of module 1 with group members ports
5-7 plus port 9:
DGS3100# config link_aggregation group_id 1 master_port 5 ports 5-7,9
Success.
aring group o