Specifications

DES-3000 Series Layer 2 Switch CLI Reference Manual
DES-3026:4#show syslog host
Command: show syslog host
Syslog Global State: Disabled
Host Id Host IP Address Severity Facility UDP port Status
------- --------------- -------------- -------- -------- --------
1 10.1.1.2 All Local0 514 Disabled
2 10.40.2.3 All Local0 514 Disabled
3 10.21.13.1 All Local0 514 Disabled
Total Entries : 3
DES-3026:4#
config log_save_timing
Purpose Used to configure automatic saving of log to Syslog host.
Syntax
config log_save_timing [time_interval <min 1-65535> | on_demand |
log_trigger]
Description
The config log_save_timing command is used to configure the terms of saving
Switch logs to designated hosts.
Parameters
time_interval <min 1-65535> − Specifies the minimum interval between saves in
minutes.
on_demand – Specifies that logs are saved when requested by the host
receiving the log.
log_trigger – Specifies that logs are saved when previously configured triggers
require the log to be saved to the Syslog host. Use config syslog host command
to determine what triggers are used.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure log timing:
DES-3026:4#config log_save_timing log_trigger
Command: config log_save_timing log_trigger
Warning: If too many logs are produced, the flash will be worn down
soon!!!
Success
DES-3026:4#
show log_save_timing
Purpose Used to display the method currently used for automatic saving of log to
Syslog host.
Syntax
show_save_timing
Description
The show log save timeing command will display the current configuration
of saving Switch logs to designated hosts.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
65