Specifications

DES-3000 Series Layer 2 Switch CLI Reference Manual
show syslog
Purpose Used to display the syslog protocol status as enabled or disabled.
Syntax
show syslog
Description
The show syslog command displays the syslog status as enabled
or disabled.
Parameters None.
Restrictions None.
Example usage:
To display the current status of the syslog function:
DES-3026:4#show syslog
Command: show syslog
Syslog Global State: Enabled
DES-3026:4#
create syslog host
Purpose Used to create a new syslog host.
Syntax
create syslog host <index 1-4> {severity [informational | warning | all] | facility [local0 |
local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> |
ipaddress <ipaddr> | state [enable | disable]}
Description
The create syslog host command is used to create a new syslog host.
Parameters
<index 1-4> − Specifies that the command will be applied to an index of hosts. There are
four available indexes, numbered 1 through 4.
severity − Severity level indicator. These are described in the following:
Bold font indicates that the corresponding severity level is currently supported on the Switch.
Numerical Severity
Code
0 Emergency: system is unusable
1 Alert: action must be taken immediately
2 Critical: critical conditions
3 Error: error conditions
4 Warning: warning conditions
5 Notice: normal but significant condition
6 Informational: informational messages
7 Debug: debug-level messages
informational − Specifies that informational messages will be sent to the remote host. This
corresponds to number 6 from the list above.
warning − Specifies that warning messages will be sent to the remote host. This corresponds
to number 4 from the list above.
all − Specifies that all of the currently supported syslog messages that are generated by the
Switch will be sent to the remote host.
facility − Some of the operating system daemons and processes have been assigned Facility
values. Processes and daemons that have not been explicitly assigned a Facility may use
any of the "local use" facilities or they may use the "user-level" Facility. Those Facilities that
have been designated are shown in the following: Bold font indicates the facility values that
the Switch currently supports.
60