Specifications

DES-3000 Series Layer 2 Switch CLI Reference Manual
create snmp host


Authentication − determines if an SNMP message is from a
valid source.
Encryption − scrambles the contents of messages to prevent
it being viewed by an unauthorized source.
noauth_nopriv − Specifies that there will be no authorization and no
encryption of packets sent between the Switch and a remote SNMP
manager.
auth_nopriv − Specifies that authorization will be required, but there
will be no encryption of packets sent between the Switch and a
remote SNMP manager.
auth_priv − Specifies that authorization will be required, and that
packets sent between the Switch and a remote SNMP manger will
be encrypted.
<auth_sting 32>
− An alphanumeric string used to authorize a
remote SNMP manager to access the Switch’s SNMP agent.
Restrictions Only administrator-level users can issue this command.
Example usage:
To create an SNMP host to receive SNMP messages:
DES-3026:4#create snmp host 10.48.74.100 v3 auth_priv public
Command: create snmp host 10.48.74.100 v3 auth_priv public
Success.
DES-3026:4#
delete snmp host
Purpose Used to remove a recipient of SNMP traps generated by the Switch’s
SNMP agent.
Syntax
delete snmp host <ipaddr>
Description
The delete snmp host command deletes a recipient of SNMP traps
generated by the Switch’s SNMP agent.
Parameters
<ipaddr> − The IP address of a remote SNMP manager that will
receive SNMP traps generated by the Switch’s SNMP agent.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete an SNMP host entry:
DES-3026:4#delete snmp host 10.48.74.100
Command: delete snmp host 10.48.74.100
Success.
DES-3026:4#
37