Specifications

DES-3000 Series Layer 2 Switch CLI Reference Manual
config dst
e_wday - Configure the day of the week in which DST ends.
• <end_weekday sun-sat> - The day of the week in which DST ends
expressed using a three character abbreviation (sun, mon, tue, wed, thu,
fri, sat)
•
•
• <start_time hh:mm> - Time is expressed using a 24-hour clock, in hours
and minutes.
•
s_date - Configure the specific date (day of the month) to begin DST.
•
•
s_mth - Configure the month in which DST begins.
e_mth - Configure the month in which DST ends.
s_time – Configure the time of day to begin DST.
e_time - Configure the time of day to end DST.
e_date - Configure the specific date (day of the month) to begin DST.
offset [30 | 60 | 90 | 120] - Indicates number of minutes to add or to subtract during
the summertime. The possible offset times are 30, 60, 90, 120. The default value
is 60.
Restrictions Only administrator-level users can issue this command.
<start_mth 1-12> - The month to begin DST expressed as a number.
<end_mth 1-12> - The month to end DST expressed as a number.
<end_time hh:mm> - Time is expressed using a 24-hour clock, in hours
and minutes.
<start_date 1-31> - The start date is expressed numerically.
<end_date 1-31> - The end date is expressed numerically.
Example usage:
To configure daylight savings time on the Switch:
DES-3026:4# config dst repeating s_week 2 s_wday tue s_mth 4
s_time 15:00 e_week 2 e_wday wed e_mth 10 e_time 15:30 offset 30
Command: config dst repeating s_week 2 s_wday tue s_mth 4 s_time
15:00 e_week 2 e_wday wed e_mth 10 e_time 15:30 offset 30
Success.
DES-3026:4#
show time
Purpose Used to display the current time settings and status.
Syntax
This will display system time and date configuration as well as display
current system time.
Parameters None.
Restrictions
show time
Description
None.
Example usage:
To show the time settings:
164