Specifications
DES-3000 Series Layer 2 Switch CLI Reference Manual
config cpu access_profile
ip − Specifies that the Switch will look into the IP fields in each packet.
protocol_id <value 0-255> − Specifies that the switch will examine the Protocol field in each
packet and if this field contains the value entered here, apply the following rules.
user_define_mask <hex 0x0-0xffffffff> − Specifies that the rule applies to the IP protocol ID
and t he mask options behind the IP header.
• destination_mac <macaddr> − Specifies that the access profile will apply to this
destination MAC address.
• 802.1p <value 0-7> − Specifies that the access profile will apply only to packets with this
802.1p priority value.
• ethernet_type <hex 0x0-0xffff> − Specifies that the access profile will apply only to
packets with this hexadecimal 802.1Q Ethernet type value in the packet header.
• offset_0-15 - Enter a value in hex form to mask the packet from byte 0 to byte 15.
• vlan <vlan_name 32> − Specifies that the access profile will apply to only this VLAN.
• source_ip <ipaddr> − Specifies that the access profile will apply to only packets with this
source IP address.
• destination_ip <ipaddr> − Specifies that the access profile will apply to only packets with
this destination IP address.
• dscp <value 0-63> − Specifies that the access profile will apply only to packets that have
this value in their Type-of-Service (DiffServ code point, DSCP) field in their IP packet
header
• icmp − Specifies that the Switch will examine the Internet Control Message Protocol
(ICMP) field within each packet.
• type <value 0-255> − Specifies that the access profile will apply to this ICMP
type value.
• code <value 0-255> − Specifies that the access profile will apply to this ICMP
code.
• igmp − Specifies that the Switch will examine the Internet Group Management Protocol
(IGMP) field within each packet.
• type <value 0-255> − Specifies that the access profile will apply to packets that
have this IGMP type value.
• tcp − Specifies that the Switch will examine the Transmission Control Protocol (TCP)
field within each packet.
• src_port <value 0-65535> − Specifies that the access profile will apply only to
packets that have this TCP source port in their TCP header.
• dst_port <value 0-65535> − Specifies that the access profile will apply only to
packets that have this TCP destination port in their TCP header.
• udp − Specifies that the Switch will examine the Transmission Control Protocol (TCP)
field within each packet.
• src_port <value 0-65535> − Specifies that the access profile will apply only to
packets that have this UDP source port in their header.
• dst_port <value 0-65535> − Specifies that the access profile will apply only to
packets that have this UDP destination port in their header.
• protocol_id <value 0-255> − Specifies that the Switch will examine the protocol field in
each packet and if this field contains the value entered here, apply the following rules.
• packet_content_mask – Specifies that the Switch will mask the packet header beginning
with the offset value specified as follows:
• offset_16-31 - Enter a value in hex form to mask the packet from byte 16 to byte 31.
• offset_32-47 - Enter a value in hex form to mask the packet from byte 32 to byte 47.
135