User's Manual

Troubleshooting (continued)

• If the device is not working properly and a yellow exclamation

mark is displayed, then there is probably a resource conflict. In

this case, make sure the computer system has a free IRQ and if

necessary, uninstall the drivers, restart the system, and repeat

the driver installation procedure.

3. The computer with the wireless adapter installed is unable to

connect to the wireless network.

• In Infrastructure mode, make sure the same Service Set

Identifier (SSID) is specified on the settings for the wireless

clients and access points. The SSID factory default setting for

the D-Link products is Default. (Please refer to Checking the

Wireless Configuration in the Networking Basics section of

this manual for more information.)

• In Ad-Hoc mode, both wireless clients will need to have the same

SSID. Please note that it might be necessary to set up one client

to establish a BSS (Basic Service Set) and wait briefly before

setting up other clients. This prevents several clients from trying

to establish a BSS at the same time, which can result in multiple

singular BSSs being established, rather than a single BSS with

multiple clients associated to it. (Please see the Status Tab in

Linkmon in the Configuration Utilities section or see Checking

the Wireless Configuration in the Networking Basics section

of this manual to learn more about BSS-Basic Service Set.)

• Check that the Network Connection for the wireless client is

configured properly. Select AP (Infrastructure) when connecting

to an access point and select Ad-Hoc mode when connecting

without an access point. Double-click on the network

connection icon in the taskbar > click on Properties > click on

Configure > select the Settings Tab > click on Modify to change

the settings for the wireless adapter. (Please refer to Checking

the Wireless Configuration in the Networking Basics section

of this manual for more information.)

• Verify that the Turbo Mode setting is exactly the same for

wireless clients and the access point. Please note that the

wireless connection will not be established in Infrastructure or

Ad-Hoc mode if Turbo Mode is enabled on one end of the

wireless connection and not the other. (Please refer to Checking

the Wireless