User's Manual

16
Using the Configuration Utility
The Configuration Utility program for the DWL-5000AP is web-based. You
will need a JavaScript-enabled web-browser such as the Internet Explorer
4.0 or higher, or the Netscape Navigator 4.0 or higher. The computer that
you are using for initial configuration must have an IP Address within
the same range as the IP Address of the DWL-5000AP. (Please refer to
the Quick Installation Guide for more information.) If you are using a D-Link
router in your network, such as the DI-704P, with the factory default settings,
you will not need to assign a static IP Address. However, if you are not
using a D-Link router in your network, you will need to assign a Static IP
Address, within the IP Address Range of the DWL-5000AP. (Please see
Networking Basics in this manual for information on Assigning a Static IP
Address.)
To use the Configuration Utility, open the web-browser and type in the IP
Address of the DWL-5000AP. The DWL-5000AP IP Address is shown below:
The screen below will appear.
•
••
• Open the web browser
•
••
• Type in the IP Address of
the Access Point
•
••
• Type Admin in the User
Name field (Upper case
A, lower case dmin)
•
••
• Leave the Password
blank
•
••
• Click OK
•
••
• Click
Configuration