User Manual

24mm

(15/16")

83mm (3.1/4")

LOCK BODY

KEEPER

FRONT TEMPLATESIDE TEMPLATE

Keeper in

side

position

WALL, FRAME

or POST

ALLOW 75mm (3") CLEARANCE 

FOR HANDLE

25mm(1")

AND 13mm (1/2") MAXIMUM GAP

ALLOW 3 mm (1/8") MINIMUM GAP

FACE OF FRAME THAT

THE LOCK BODY IS

MOUNTED TO FOR A

LEFT-HAND OPENING

FACE OF POST THAT THE

SIDE-MOUNT KEEPER

IS MOUNTED TO

FACE OF FRAME

FOR A

RIGHT-HAND OPENING

25mm(1")

DRILLING TEMPLATE

PULLBOLT SIDE-MOUNT MODEL

PULLB000029PA •Instr_D&DPullBolt_SM (20/6/05)

IMPORTANT: If printing these Instructions

from an electronic ﬁle (e.g. website download),

be sure to check that dimensions shown here

measure correctly, as differences in print-outs

may result in inaccurate template holes.

PAGE 1
PULLB000029PA •Instr_D&DPullBolt_SM (20/6/05) A 24mm (15/16") WALL, FRAME or POST Keeper in side position SIDE TEMPLATE FACE OF FRAME THAT THE LOCK BODY IS MOUNTED TO FOR A LEFT-HAND OPENING FACE OF FRAME FOR A RIGHT-HAND OPENING KEEPER 25mm(1") 25mm(1") DRILLING TEMPLATE E FACE OF POST THAT THE SIDE-MOUNT KEEPER IS MOUNTED TO E FRONT TEMPLATE D LOCK BODY A A IMPORTANT: If printing these Instructions from an electronic file (e.g.
PAGE 2
Changing from left- to right-hand fitting 1. Remove the key and place the Lock Body face down. Remove the four corner screws but DO NOT REMOVE the two center screws (shown at A). 2. Pick up the Lock Body with both hands, being careful to hold together the front and back covers (to prevent internal components moving). Turn over the Lock Body and place down on a flat surface. 3. Lift the front cover and place to one side.
PAGE 3
FITTING INSTRUCTIONS SIDE-MOUNT MODEL The D&D PullBolt™ is designed to provide added security to shop fronts, doors, frames and gates. The locking mechanism is a “deadlock” design, meaning that it has to be locked in either the open or closed positions to allow removal of the key. The PullBolt has a throw of 11/4” (32mm) and remains captured in the Lock Body when locked in the open position.