MSDS

D0263011 v3.0
Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
8. Exposure controls/personal protection
Hand protection
Use a properly fitted, particulate filter respirator complying with an approved standard if a
risk assessment indicates this is necessary. Respirator selection must be based on
known or anticipated exposure levels, the hazards of the product and the safe working
limits of the selected respirator.
Chemical-resistant, impervious gloves complying with an approved standard should be
worn at all times when handling chemical products if a risk assessment indicates this is
necessary. Considering the parameters specified by the glove manufacturer, check
during use that the gloves are still retaining their protective properties. It should be
noted that the time to breakthrough for any glove material may be different for different
glove manufacturers. In the case of mixtures, consisting of several substances, the
protection time of the gloves cannot be accurately estimated.
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists,
gases or dusts. If contact is possible, the following protection should be worn, unless
the assessment indicates a higher degree of protection: safety glasses with side-shields.
Eye/face protection
Respiratory protection
:
:
:
Body protection
Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before handling
this product.
:
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period. Appropriate
techniques should be used to remove potentially contaminated clothing. Wash
contaminated clothing before reusing. Ensure that eyewash stations and safety showers
are close to the workstation location.
Hygiene measures
:
Skin protection
Other skin protection
:
Appropriate footwear and any additional skin protection measures should be selected
based on the task being performed and the risks involved and should be approved by a
specialist before handling this product.
9. Physical and chemical properties
Physical state
Melting point
Vapor pressure
Relative density
Vapor density
Solubility
Solid. [Block]
54.444°C (130°F)
Not available.
Not available.
Not available.
Insoluble in the following materials: cold water and hot water.
Characteristic.
Odor
pH
Green.
Color
Evaporation rate
Not available.
Flash point
Closed cup: >190.56°C (>375°F)
Not available.
Not available.
Not available.
Odor threshold
Partition coefficient: n-
octanol/water
:
:
:
:
:
:
:
:
:
:
:
:
:
Appearance
Boiling point
:
Not available.
Flammability (solid, gas)
:
Not available.
Lower and upper explosive
(flammable) limits
:
Not available.
5/11
26/05/2015.
Date of issue
:
SDS #
FF8121078 (D0263011)
:
Code #
D0263011 v3.0
: