MSDS

D0263011 v3.0
Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
6. Accidental release measures
Environmental precautions
Personal precautions, protective equipment and emergency procedures
Move containers from spill area. Approach release from upwind. Prevent entry into
sewers, water courses, basements or confined areas. Avoid dust generation. Do not dry
sweep. Vacuum dust with equipment fitted with a HEPA filter and place in a closed,
labeled waste container. Dispose of via a licensed waste disposal contractor. Note: see
Section 1 for emergency contact information and Section 13 for waste disposal.
:
:
No action shall be taken involving any personal risk or without suitable training.
Evacuate surrounding areas. Keep unnecessary and unprotected personnel from
entering. Do not touch or walk through spilled material. Provide adequate ventilation.
Wear appropriate respirator when ventilation is inadequate. Put on appropriate personal
protective equipment.
Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains and
sewers. Inform the relevant authorities if the product has caused environmental pollution
(sewers, waterways, soil or air).
Large spill
:
Move containers from spill area. Avoid dust generation. Using a vacuum with HEPA
filter will reduce dust dispersal. Place spilled material in a designated, labeled waste
container. Dispose of via a licensed waste disposal contractor.
Small spill
:
Methods and materials for containment and cleaning up
For non-emergency
personnel
For emergency responders
:
If specialised clothing is required to deal with the spillage, take note of any information in
Section 8 on suitable and unsuitable materials. See also the information in "For non-
emergency personnel".
7. Handling and storage
Conditions for safe storage,
including any
incompatibilities
Store in accordance with local regulations. Store in original container protected from
direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials
(see Section 10) and food and drink. Keep container tightly closed and sealed until
ready for use. Containers that have been opened must be carefully resealed and kept
upright to prevent leakage. Do not store in unlabeled containers. Use appropriate
containment to avoid environmental contamination.
:
Protective measures
Put on appropriate personal protective equipment (see Section 8). Do not ingest. Avoid
contact with eyes, skin and clothing. Keep in the original container or an approved
alternative made from a compatible material, kept tightly closed when not in use. Empty
containers retain product residue and can be hazardous. Do not reuse container.
:
Precautions for safe handling
Not applicable.
8. Exposure controls/personal protection
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked to ensure they
comply with the requirements of environmental protection legislation. In some cases,
fume scrubbers, filters or engineering modifications to the process equipment will be
necessary to reduce emissions to acceptable levels.
Appropriate engineering
controls
:
Good general ventilation should be sufficient to control worker exposure to airborne
contaminants.
Control
Individual protection measures
Occupational exposure limits
4/11
26/05/2015.
Date of issue
:
SDS #
FF8121078 (D0263011)
:
Code #
D0263011 v3.0
: