User manual

(4.0 E) 1-1
1. Introduction
This user manual describes the facilities, functions and operation of
d&b active controller loudspeaker systems and covers the operati-
on of the A1 mainframe, controller modules and loudspeakers used
in these systems.
d&b publishes additional application and technical information not-
es (TI). A d&b publications list and order form is appended to this
manual and we will gladly send you any of the listed publications
on request.
This user manual should provide the information you need in order
to get the best performance out of the system. If you have any
comments on the information presented, or feel that something is
inadequately explained or not covered, then please tell us using
the comments section of the publication order form.
1.1. System concept
All d&b loudspeaker systems are designed to meet the following
criteria :
- Consistent neutral sound over the full working dynamic range
- Ease of operation
- Simple set up and wiring
- Safe and reliable operation
- Compact design
In order to satisfy these demands d&b developed a complete
system concept incorporating the loudspeaker, the loudspeaker
specific control electronics (the controller) and the power amplifier.
Fundamental to the performance of the loudspeaker is the care
taken in the development of individual components resulting in well
controlled dispersion, high efficiency and excellent dynamic
response.
The controller creates the optimum mix of output level capability,
operating reliability and longevity, and pure sound quality.
Protective circuits continuously model the loudspeaker load through
simulation of cone displacement and voice coil temperature
ensuring signal level is only reduced when necessary to prevent
driver damage. No signal compression takes place within the
systems normal operating range and there is no dynamic
manipulation of system frequency response enabling most
applications and acoustic environments to require no additional
signal processing.
The power amplifier and control for each loudspeaker are housed
within the A1 and P1200A mainframes or the E-PAC power
amplifier controller. All systems are compatible, easily combined
and complementary, and can be accessed using the d&b remote
control system to allow overview and control over the most
complex applications.