Specifications

TI 323 (6.0E)
7 - 36
Dimensions (HxWxD): 3 RU x 19“ x 13.9“
Weight: 22 kg/48.5 lb (with modules)
INPUT LINK
INPUT A
INPUT LINK
MONO OUT
INPUT B
OUT CHANNEL A
OUT CHANNEL B
REMOTE
CONTROL
FUSE T2A
220V-240V~
50-60 Hz
2200 W max
OVER
VOLTAGE
FUSE T8A FAIL
FAIL
CAUTION
P1200A Mainframe
Weight: 22 kg / 49 lbs
Z2300000121236
Made in Germany
®
e-mail: [e-mail]
OFF
ON
REM
PWR
TEMP
REM
PROT
LOCK
AB
Dimensions (HxWxD): 3 RU x 19“ x 13.9“
Weight: 22 kg/48.5 lb (with modules)
OUTPUT
PIN ASSIGNMENT
A LOW OUT +
B LOW OUT -
C SPEAKER ID
D SPEAKER ID
E SENSE DRIVE +
F SENSE DRIVE -
G nc
H nc
B2
INPUT
INPUT LINK
C4 OUT
REMOTE
CONTROL
FUSE T2A
220V-240V
∼
50-60 Hz
2200 W max
OVER
VOLTAGE
FUSE T8A FAIL
FAIL
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
P1200A Mainframe
Weight: 22 kg / 49 lbs
Z2300000121236
Made in Germany
®
e-mail: [e-mail]
2. System amplification
Suitable for use with all d&b C-Series systems, the
P1200A mainframe (2 x 600 W / 4 ohms) has
two front panel slots to accommodate one or two
loudspeaker specific controller modules. In the case of
the C4/C7 loudspeakers one channel of a P1200A
mainframe can drive up to two cabinets.
Single mainframes can be fitted with both TOP and
SUB modules to drive mid/high cabinets on one
channel and subwoofers on the other, two C4-TOP
and two C4-SUB loudspeakers can then be fed by a
single four core cable from the mainframe and
connected in a daisy chain.
Alternatively, single mainframes can be fitted with two
identical TOP or SUB controller modules to create
stereo mid/high or subwoofer systems.
The C3 loudspeaker is a 2-way active design and
therefore requires both channels of a P1200A. Up to
two C3 loudspeakers can be driven by a P1200A
power amplifier fitted with the C3 controller module.
To avoid HF loss with long cable runs each cabinet
must be connected to one of the mainframe outputs
using separate cables with a minimum cunductor size
of 4 x 2.5 mm
2
(13 AWG).
The A1 mainframe (1200 W/350 W/4 ohms) the
dedicated mainframe for d&b's active systems. Fitted
with a B2 controller module it drives the B2-SUB which
is used for infrabass enhancement of C4 systems. The
B2 controller also provides a filtered and buffered
low impedance output, the C4 OUT, that can be used
to drive C4 controllers when they are used in
combination with B2-SUBs.
The modular nature of these individual systems lends
itself to the creation of customized sound
reinforcement designs which allow for future
expansion or reconfiguration when the need arises.