User manual

(4.0E) 4-3
IMPORTANT!
MIX IN INPUTSPEAKER OUT
REMOTE INPUT LINK
REMOTE
LO IMP
DELAY ON
CUT
HFA
SPKR
21 3456 87
ON
E- PAC
INPUT SIGNAL R
INPUT SIGNAL L
MIX IN INPUTSPEAKER OUT
REMOTE INPUT LINK
REMOTE
LO IMP
DELAY ON
CUT
HFA
SPKR
21 3456 87
ON
E- PAC
MIX IN INPUTSPEAKER OUT
REMOTE INPUT LINK
REMOTE
LO IMP
DELAY ON
CUT
HFA
SPKR
21 3456 87
ON
E- PAC
LINK LINK
E12-SUB
E3 E3
Wiring of a stereo system with a mono subwoofer
4.3. Using the E-PAC MIX IN
The E-PAC is a single channel amplifier controller, the rear panel
connectors allow for use in different configurations. The illustration
below shows two E-PACs driving E3 loudspeakers from a stereo
source, a third E-PAC drives an E12-SUB in mono. The left and
right signals are summed to mono using the MIX input on the third
E-PAC. Please note that the resultant output will be 3 db higher
(see section 2.10.) .
The output on the INPUT LINK connector is derived from the signal
to the INPUT connector. An additional signal fed to the MIX IN
connector will not appear at the INPUT LINK output.