User manual

(4.0E) 2-9
Attachment of brackets and rack ears
1
2
S
E-PACs with single/dual rack mount kit
1
2
3
4
5
Rack mount kit parts
IMPORTANT!
2.11. Installation
A single E-PAC, or a pair side by side, may be installed in a
standard 19" equipment rack or flightcase. E-PACs require two
rack units and, including connectors, a minimum rack depth of 40
cm (15.7 "), mounting ridge to rack rear panel.
The single rack mount kit (Z2501) allows one E-PAC to be mounted
either to the left or the right hand side. It includes the following
parts:
− 1 front blanking panel (5)
− 1 front rack mounting bracket (2)
− 1 rear mounted rack ear (3)
− 4 mounting rails (1)
− Allen screws (S), Allen (Hex) srew
The dual rack mount kit (Z2502) includes the following parts:
− 2 front rack mounting brackets (2)
− 2 rear mounted rack ears (3)
− 2 connector brackets (4)
− 8 mounting rails (1)
− Allen screws (S), Allen (Hex) srew
The mounting rails are inserted into channels located in the side
walls of the E-PAC aluminum enclosure. The different fittings are
attached using countersunk Allen screws.
It is recommended that additional support be provided within the
rack by using the rear mounted rack ears. This is particularly
important if E-PACs are being racked for road use.