User manual

C6-MON (1.1E)
Controls on C6
controller module
+$
CUT
GRISP
MUTE
OVL
-12 dB
-6
+6
0
MON
160Hz
C6 controller module switches
Standard setting
If the CUT switch and MON switch are not selected the module is
configured for use with C6 loudspeakers used as a stand alone
system without subwoofers.
CUT switch & indicator
Set to CUT, a high pass filter with a 110 Hz cut-off frequency is
inserted in the controller signal path. The yellow CUT LED
illuminates. The C6 system is now configured for use with d&b
C-Series active subwoofers.
MON switch & indicator
If the MON switch is selected the yellow MON LED illuminates and
the low frequency level is reduced by 3 dB. This particularly applies
to the C6-MON stage monitor, as this setting reduces the low
frequency energy gained from the coupling effect of floor
placement.
160 Hz setting (CUT & MON switches both selected)
If the 160 Hz mode is selected, a high pass filter is inserted in the
controller signal path. The crossover frequency of 160 Hz is higher
than in CUT mode and thus increases the available headroom in
the C6 system. The 160 Hz mode can be selected when the system
is operated with d&b active subwoofers C4-SUB, C7-SUB or
E18-SUB (also in 160 Hz mode, see manual section E18-SUB). This
configuration is particularly useful when C6 loudspeakers are
stacked directly on top of the subwoofer system.