User manual

C6-MON Data Sheet C6-MON
CAUTION!
EP-5
1
2
3
4
5
NL4
1+
1
2+
2
n.c.
Speakon- NL4 and EP-5 pin assignments
Connector wiring
Passive
Crossover
1+
1
2+
2
1+
1
2+
2
C6-MON
The C6-MON is a full range, two way bass-reflex enclosure fitted
with a 12" LF driver passively connected to a 2" HF compression
driver coupled to a 60° x 40° CD horn.
A wedge shaped stage monitor with a 40° angled speaker baffle,
the C6-MON is constructed from marine plywood and has an
impact resistant paint finish. The front of the loudspeaker cabinet
is fitted with a rigid metal grill covered with a replaceable
acoustically transparent foam. Mounted on the rear panel are two
Speakon NL4 or EP-5 connectors wired in parallel. The top plate
has an integral handle and four M10 threaded inserts for attaching
installation hardware.
With a frequency response extending from 65 Hz to 17 kHz, the
C6-MON can generate a 133 dB peak sound pressure level at 1m.
This high output capability coupled with a high gain before
feedback ratio is a consequence of a linear frequency response
and controlled dispersion. The result is in an extremely efficient
stage monitor for vocal work. Faceted cabinet side panels simplify
the assembly of a twin C6-MON array covering a 100° horizontal
angle.
The top panel has a combined handle and mounting plate similar
to that of the C6 allowing the use of the same rigging accessories.
Using the Z5023 Flying bracket 02 and a high stand it is possible to
use C6-MON in a front of house system.
The C6-MON has the same electroacoustic performance as the C6
and uses the same C6 controller module. Please note, that for front
of house systems, C6-MON cabinets are not as straightforward to
array as the C6 version of the cabinet.
C6-MON can also be supplemented with the d&b active subwoofer
systems E18-SUB, C4-SUB or C7-SUB.
Only operate C6-MON loudspeakers with a d&b P1200A
mainframe fitted with C6 controller modules, otherwise there is a
risk of damaging the loudspeaker components.
Connections
The C6-MON cabinet is fitted with a pair of Speakon-NL4
connectors. All four pins of both connectors are wired in parallel.
The C6-MON uses the pin assignments 1+/1. Pins 2+/2 are
designated to C and E-Series active subwoofers. Using one
connector as the input, the second connector allows for direct
connection to additional loudspeakers.
The C6-MON can be supplied with EP-5 output connectors as an
option. Pin equivalents of Speakon-NL4 and EP-5 connectors are
listed in the table below.
Up to two C6-MON can be driven by each P1200A power
amplifier channel. Fitting one C6-CO and one subwoofer controller
module allows a single mainframe to drive two C6-MON and two
active subwoofer cabinets (E18-SUB, C4-SUB or C7-SUB). All
cabinets can be linked together locally and fed by a single four-
wire cable from either mainframe output connector.